Important -- Please Read: This is a collection of PORFLOW examples. Its uses are two fold:

1. If you need help with setting a test case with say Fracture Flow, you can go to Chapter 3 (see table of contents below) and find a problem similar to yours, copy it from "TITLE" to "END" commands, and paste into a new file. Then:

1. In CFDStudio, click "File > Import > Import Legacy Commands File" to import this new file into the CFDStudio environment, OR
2. Run the new Commands File from command mode.

2. Just as you see here, you can put more than one case  - where case means collection of commands from one "TITLE" to the first "END" following it - in the same file. Note that you need to run this kind of "multi-case" files in command mode. CFDStudio environment is designed to work with "single-case" files.

To run PORFLOW in command (ms-dos or Unix shell) mode, all you need to do is enter the following syntax at a command prompt:

porflow <input_file_name> <output_file_name>

Note: If you do not want to enter the whole path to PORFLOW executable, you will need to add your installation directory to your system path.